Super Super

Finn Bálor Toy Studio

Paper figure
Figure: Ready stance A4 · 210 × 297 mm

The preview is the exact artwork that prints. Cut on the solid line, fold on the dashed line.

Adjust the pose, paint and gear, then print a real sheet.

A paper toy you can actually build: pick a pose, choose the body paint, and print a real sheet with cut and fold guides. Everything runs in your browser — no account, no upload.

What you get

The studio renders a printable sheet sized for A4 or US Letter. Each part has a solid cut line and a dashed fold line, plus glue tabs sized to your chosen width. The preview on screen is the same artwork that goes to the printer, so what you see is what you cut.

How to build it

  1. Choose a pose. Ready stance is the easiest to assemble; the dropkick and Coup de Grâce poses look more dynamic but need a display base to stand.
  2. Pick the paint. Demon paint adds the shoulder and face markings. Crimson and black ink are simpler alternatives.
  3. Set the height. 180 mm is a comfortable desk size. Below 140 mm the glue tabs get fiddly; above 220 mm you may need two sheets.
  4. Print at 100%. Turn off "fit to page" in your print dialog, or the millimetre measurements will be wrong.
  5. Cut, fold, glue. Score the dashed lines with a blunt knife before folding. Glue tabs go inside the body.

Fan-made, not official. This is an original craft project inspired by Finn Bálor's look. It is not licensed, endorsed by, or affiliated with WWE or the wrestler. Use it for personal craft only.

Pose guide

PoseDifficultyNeeds baseBest for
Ready stanceEasyNoFirst build, desk display
Arms raisedEasyNoEntrance pose
DropkickMediumYesAction shelf
Coup de GrâceHardYesDiorama centrepiece

Paper and printing

Use 160–200 gsm card stock for a toy that holds its shape. Standard 80 gsm paper works but the figure will flop. Matte stock takes pencil and marker touch-ups better than gloss. If you only have a mono printer, the line art still prints cleanly — the paint is optional.

Questions

Is this an official Finn Bálor toy?

No. It is an original fan-made paper craft inspired by his look. It is not licensed or endorsed by WWE or the wrestler, and it is intended for personal, non-commercial craft use.

Why does my print come out the wrong size?

Most print dialogs default to "fit to page", which scales the artwork. Set scaling to 100% or "actual size" so the millimetre measurements on the sheet are accurate.

Can I resize the toy?

Yes. The figure height slider goes from 120 mm to 240 mm. Very small figures have tight glue tabs; very large ones may need the parts split across two sheets.

Does anything get uploaded?

No. The whole studio runs locally in your browser. Nothing you choose is sent anywhere.